April 11, 20233 yr I'm experiencing a jittery or jerky airspeed indicator. The needle jumps back and forth. It could be at 140, then in an instant it's 150, then 140, then 145 all happening in 2-3 seconds. This happens while the plane is on the air. It is almost impossible to land. What is causing that and how is it fixed? Everything else seem to be running fine. All the other dials run smoothly. And there is no shimmering on the panel and the instrument are clear or not blurry. I have FPS set to unlimited and framerate runs at about 25-30 FPS on average. Thank you. Test hardware: low-end i7-8700k, 3060ti, 32gb ram, Beam Eye Tracker and Quest. --MSFS 20-24, DCS, medium settings. Good fps. Test software: vintage Win10 Pro, P3D4.5 w/ 100+ add-ons + FSX.
April 11, 20233 yr 8 hours ago, bofhlusr said: I'm experiencing a jittery or jerky airspeed indicator. You can try turning off weather to see if wind gusts are an issue, and also make sure pitot heat is on. Other than that I have no idea what on your setup could be causing that problem. Al Edited April 11, 20233 yr by ark
April 11, 20233 yr Author 5 hours ago, ark said: You can try turning off weather to see if wind gusts are an issue, and also make sure pitot heat is on. Other than that I have no idea what on your setup could be causing that problem. Al You were right. I changed from "fair weather" to "clear skies" and the airspeed indicator stopped jumping around. (I had pitot heat on). Thank you, Al, Test hardware: low-end i7-8700k, 3060ti, 32gb ram, Beam Eye Tracker and Quest. --MSFS 20-24, DCS, medium settings. Good fps. Test software: vintage Win10 Pro, P3D4.5 w/ 100+ add-ons + FSX.
Archived
This topic is now archived and is closed to further replies.