no matter what, atc wont recognize my squawk setting. transponder is in alt and on mode but nothing. setting it via atc menu (acknowledge squawk code) also doesnt work. so in vfr I dont have any flight following/nearest airports options and ifr gets cancelled because atc doesnt verify me setting the assignes squawk... what am I doing wrong this is driving me nuts... 

I will assume you are talking about the C414, but don't know what panel and therefore what transponder.  In any case, as a start suggest you try using a default Flysimware livery and without any mods in the Community folder, and an updated version of the C414.

Al

yup sorry forgot to mention that 🙂
I just found out its because with the lvars I binded to my FIPs, the transponder signal light (that little orange lamp on the transponder) doesnt turn on. With mouse works fine. If anyone has the correct binding fot this Id really appreciate. The transponder switches move but dont actually set the transponder to on/alt..

I completely forgot there is also a GTN750 version, Im talking about the WTGNS530 Version (rt 859 transponder)

If I turn on the battery master and avionics master switches by mouse, the keybind does work: LVAR:GENERIC_XPNDR_ON to 1

however, when turning on the battery and avionics master switch with keybinds: LVAR:GENERIC_ELECTRICAL_SWITCH_BATTERY_MASTER_1 to1
                                                                                                                                BUS BREAKER PULLED:4 to 0
                                                                                                                                BATTERY_1_SET to 1
and
                                                                                                                                LVAR:GENERIC_ELECTRICAL_AVIONICS_MASTER_1 to1
                                                                                                                                BUS BREAKER PULLED:4 to 0

then                                                                                                                         LVAR:GENERIC_XPNDR_ON to 1 doesnt do anything....


                                                                                                 

meant BUS BREAKER PULLED:6 to 0 for the BATTERY...

If you are using Spad.Next to bind the battery and Avionics switches I think you will find the info you need on the Flysimware Discord site under HARDARE BINDING SUPPORT > #Spadnext. The electrical system has been updated recently to incorporate circuit breakers, so updated code is needed for some of the switches like the battery and avionic switches.

Al

Edited April 29, 20233 yr by ark