January 15, 20242 yr Commercial Member 59 minutes ago, flyforever said: The device is recognized, but the green icon makes the axis names flash very rapidly, and the turning of the trim wheel does not change to the correct axi Ignore the unwanted axis inputs with the orange exclamation mark (= the one that is next to the axis field) until only the trim wheel is left? Edited January 15, 20242 yr by Lorby_SI LORBY-SI
January 15, 20242 yr 1 hour ago, Lorby_SI said: Ignore the unwanted axis inputs with the orange exclamation mark (= the one that is next to the axis field) until only the trim wheel is left? I am not sure I understand. I will upload an image for clarity. Tks.
January 15, 20242 yr Commercial Member 7 minutes ago, flyforever said: I am not sure I understand. I will upload an image for clarity. Tks. When you get rapidly changing axis designations in the box because of the high sensitivity mode, you can click on the orange exclamation mark to ignore the axis that is currently displayed. So by ignoring one after the other you should eventually arrive with only the trim wheel being left. LORBY-SI
January 15, 20242 yr This time it worked, just as you described.Thank you for your patience on this matter. I've struggled with it for months. Finally, a good explanation to getting a high res axis to be recognized. I hope you add this important item in the manual.
Archived
This topic is now archived and is closed to further replies.