April 2, 20242 yr Hi, I know this is a legacy product, but was wondering if the following could be clarified... The manual states that the Transition Level should be set in the DES FORECASTS page of the FMC. However it appears that the Transition Level call during descent takes it's value from the Transition Altitude value in the PERF INIT page instead. Is this correct? I did see a very old post suggesting the correct value couldn't be read from the aircraft (iFly SDK limitation?), but was wondering if this was still the case for the final version? The workaround suggested was to change the PERF INIT page value mid-flight, but I don't believe that page is accessible once in the air. This is for P3Dv4.5 using the iFly 737NG and FS2Crew Voice. Many thanks Phil Edited April 2, 20242 yr by Phil Reynolds Spelling
April 4, 20242 yr Commercial Member This is going back over 10 years, but looking at their SDK again, all we can read is the Transition Altitude. B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
Archived
This topic is now archived and is closed to further replies.