February 3, 20251 yr HI, I have been using Pilot2ATC v2 for both msfs2020 and Xplane 12. I must say it is an excellent ATC and flight planning software. I have the VHHH - Hong Kong International Airport (from Taimodels) which has been updated to a 3-runway operation, however in Pilot2atc I can only see 2 runways instead of 3. Wonder if it is possible to update the airport information in pilot2atc. Many thanks. [email protected], ASUS TUF GAMING Z690-PLUS WIFI D4, Noctua NH-U12S, G.SKILL 32GB Kit F4-3600C16D-32GTZNC Trident Z Neo RGB DDR4 3600MHz, SanDisk Extreme Pro SSD 1TB, WD Black SN850X NVMe SSD 4TB, Inno3D RTX 4080Ti, Cooler Master V750 Gold 750W PSU, Win11 Pro, Dell 24" 2408WFP 1920x1200 30 , Fulcrum One Yoke, MFG Crosswind V2 rudder pedal, Saitek Throttle Quadrant, Logitech Cessna Trim Wheel, Saitek Multi Panel, DIY Cessna 172 Radio stack (via Arduino/MobiFlight), Air manager V5 on 10" 1920x1080 monitor
February 6, 20251 yr Commercial Member You can import the taxiway data from the SIM using the Taxi Mnt feature of V2. See the Operations manual for details on how to do it for your SIM. Dave
September 9, 2025Sep 9 Author Hello Dave, Thanks for your advice. By following the instructions in the manual, I was able to import the taxiways in X-plane 12 successfully. Unfortunately, I still could not get the new runway. Further advice would be most appreciated. KK [email protected], ASUS TUF GAMING Z690-PLUS WIFI D4, Noctua NH-U12S, G.SKILL 32GB Kit F4-3600C16D-32GTZNC Trident Z Neo RGB DDR4 3600MHz, SanDisk Extreme Pro SSD 1TB, WD Black SN850X NVMe SSD 4TB, Inno3D RTX 4080Ti, Cooler Master V750 Gold 750W PSU, Win11 Pro, Dell 24" 2408WFP 1920x1200 30 , Fulcrum One Yoke, MFG Crosswind V2 rudder pedal, Saitek Throttle Quadrant, Logitech Cessna Trim Wheel, Saitek Multi Panel, DIY Cessna 172 Radio stack (via Arduino/MobiFlight), Air manager V5 on 10" 1920x1080 monitor
September 9, 2025Sep 9 Commercial Member Some 3rd party airport designers provide the visible scenery without providing the data needed to import the taxiways. P2A looks for lines in the airport.dat file that start with 1201, 1202, 1204. If these lines are not in the .dat file, then P2A won't be able to import them properly. But since the import "succeeded" it sounds like you imported the original airport definition from X-Plane rather than the new 3rd party one. Make sure your sceneries.ini file is defined correctly so that the Taimodels .dat file is used for that airport. Dave
Create an account or sign in to comment