KKLEE

Finally, one of the push buttons stuck. I ordered a C&K 8125 switch from a supplier in Taobao and successfully replaced the defective one in the yoke. As mentioned by some other users, the feel of this new one is a little bit different. The travel is slightly shorter. Here is the link of a photo of the two switches. The one on the left hand side is the C&K replacement while another one is the original defective switch. https://www.amazon.com/photos/shared/L422uVuYQCuFwy_NhvdAQQ.j6n7jjFYYqtkxLCM4CSMrr

Thanks to Chris. Problem solved. It happens that my yoke is an early version one which has both PID and VID set to 0000. MSFS2024 failed to detect this hardware ID after the latest SU5 update. Chris was so kind to follow up the issue and provided an update procedure to resolve the problem. Now the yoke works perfectly well in MSFS2024. Excellent customer support from Chis.

Hi Chris, It's good to hear from you. I have sent you an message together with a screen shot via the support email address. Once again, I would like to thank your effort in developing in manufacturing this wonderful yoke. This is one of the best yokes in the market and your service and support are excellent. I am sure many sim users would agree with me. Warmest regards, KK

After installing the latest Sim update 5 beta, Fulcrum yoke is not detected in the controller setting. The yoke still works fine in the sim just not being detected and not being able to set up the button assignments. Strangely, Tobii , which I do not have, is shown in controller setting. Anyone has similar issue/problem? Regards, KK

Unfortunately, the beta is still broken to me. It failed to detect my Fulcrum One yoke correctly and mistakenly assigned it as Toli ? A very strange bug. 😓

I have AI planes on the field but after they had taxied to the runway, they were stuck at the holding positions and did not take off. After a while, they disappeared (removed by the sim).

Thanks for your reply. Unfortunately, I have no Navigraph subscription and cannot verify this.

Hello everyone, I have FSLTL basic models and injector installed. It works fine with some default airports like KJFK, RJTT etc. Unfortunately, with a third party airport like WF Scenery VHHH, AI planes keep disappearing while departing or landing on the runways. Any suggestions or comments to resolve this issue? Many thanks.

Hello Dave, Thanks for your advice. By following the instructions in the manual, I was able to import the taxiways in X-plane 12 successfully. Unfortunately, I still could not get the new runway. Further advice would be most appreciated. KK

I have been using Pilot2ATc v2 happily for years but, all of a sudden, I got this error while trying to launch the program. Help would be much appreciated. KK

Thanks. I received the upgrade discount code but forgot to upgrade my copy of AM4 before the deadline. 😅 I have sent an email to the customer service and hopefully they will send me a new discount code.

A stupid question: Does air manager 4 work with msfs2024? I tried but it cannot find the simulator. Many thanks

HI, I have been using Pilot2ATC v2 for both msfs2020 and Xplane 12. I must say it is an excellent ATC and flight planning software. I have the VHHH - Hong Kong International Airport (from Taimodels) which has been updated to a 3-runway operation, however in Pilot2atc I can only see 2 runways instead of 3. Wonder if it is possible to update the airport information in pilot2atc. Many thanks.