Good morning. I have not been successful in setting the rudder axis in my C208, Fs 2020, in Controls, Axis and Ohs and even Spad next. It will however set in FSUIPC.  I do not have anything else assigned in FSUIPC and would prefer system Controls or AAO. This was not a problem until recently and rudder axis assignment was ok before. All flight assistance boxes are checked to off.  Controls and AAO recognize the pedals (Saitek) but there is no reaction in the aircraft (with engines running).

Any suggestions would be appreciated.

Martin

 

 

Update - I went to Windows Control panel and did the calibration thing on the rudder pedals. And now they work.

5 hours ago, Bigmarty said:

Update - I went to Windows Control panel and did the calibration thing on the rudder pedals. And now they work.

Can you be more specific about what you did? I too noticed this evening I can't change the sensitivity on my rudder pedals (MFG Crosswinds).

Yes, I just went to Windows control panel (not Settings) and brought up devices. Going from memory here, right click on the rudder pedals, then advanced and I think it brings up the calibration page. You will find it ok. I don't know if it would allow changes so sensitivity.