I have noticed that since installing the latest update to 3.1, I no longer seem to get the "my plane" or "my comms" acknowledgement when handing over control (Ctrl-Shift-K or M). Is this something with the upgrade or something else? I did change my co-pilot voices by copying over a UK male voice into the folder that is used for co-pilot - could this be where the problem lies - e.g. maybe those wavs don't exist for the pilot that I chose?Is there an easy way to switch co-pilot or pilot voices?Best regards,Stuart Hyett

first thing to check, is do you have the same number of wavs in winwood0, winwood1?jd

Thanks JD,I'll check over the weekend. btw are the pilot / copilot wavs contained in these 2 folders?Regards,Stuart

yes

I checked the folders winwood/0 and/1 and they contain actually more wavs than the original ones. What is the wav filename that causes the copilot to acknowledge "my comms"? Maybe it is missing.On another issue, I was making ashort flight the other noght from Glasgow to a west coast Scotland island. I used FSBuild 1.6 to construct my FS2004 flightplan and loaded this into RC. On receiving clearence the initial altitude was blank "...climb and maintain ..fly heading 270..". RC then continually complained that I was busting my altitude, saying "...your assigned altitude is ..." This has happened before, but not always. Any idea as to what could cause the altitude to be left out? Is it perhaps that my flightplan altitude may have been below transition altitude?Best regards,Stuart Hyett

mcomm.wav and ycomm.wavcheck the cruise altitude setting on the controllers page. remember this is in FL, so 18000 is entered as 180jd

Thanks JD,Regards,Stuart Hyett