Just tried to fly a flight. Was at the gate in the PMDG B1900. Had the door and cargo door open. RC would not let me close the cargo door. SInce options were visible in the ADV window, as soon as I hit the normal S+E+2, the main door kept opening & closing, and I kept requesting another runway. FS was not recognizing the key combination. RC was seeing the 2 as wanting option 2 in the window, and FS was just seeing the S+E. Is this something new or has this been seen before.I finally just got so frustrated, I shut down FS and am going to bed!I hope there is a solution!Rick

yep, go to the rc keyboard screen, and change your menu 1-5 keystrokes to ctrl-shift-1, ctrl-shift-2, ctrl-shift-3, etc.jd

I had this happen yesterday with the Cargo door on my LevelD 767 which I use D + 2 to open and close. Since I had already set up everything, spending about 20 minutes, I just flew the flight with the Cargo door open. Got a bit chilly in the aircraft and the crew had to wear oxygen masks, but we made it :)

>I had this happen yesterday with the Cargo door on my LevelD>767 which I use D + 2 to open and close. Since I had already>set up everything, spending about 20 minutes, I just flew the>flight with the Cargo door open. Got a bit chilly in the>aircraft and the crew had to wear oxygen masks, but we made it> :)Should something like this happen again, save the flight via the FS interface. Then, exit flight sim, start RC4 and change keyboard assignments. Exit RC. Fire up everything, load the saved situation in FS, load the saved .rcd via the RC4 interface, and continue flying.-michael

you're a breath of fresh air ;-)jd

>yep, go to the rc keyboard screen, and change your menu 1-5>keystrokes to ctrl-shift-1, ctrl-shift-2, ctrl-shift-3, etc.>>jdI stumbled across this not too long ago, but alternatively you can redfine the "Select 1"-"Select 4" keyboard commands in FS from 1-4 to four keys you are not using, say F5-F8. I always found the ctrl-shift key commands awkward to use.Mark Kuebeler