When I try to set the speed of the voices to a lower rate in the 'Customize Voices' dialog, I get the following error:F:FsToolsRc4winwood99whitepoint.wavtmpwavefile.divisor = 0When I click ok on this message box I get:Run-time error '6':RadarContact.rcv4module.pilot_ackThen RC4 closes.I recently did a complete reinstall of rc4, updated to 4.01 and then to 4.2. When I don't change the voice speed rc4 works ok.Best, Rob van der Wiele.Boeing Cockpit Projecthttp://home.hccnet.nl/r.v.d.wiele/

are you using this "silent pilot" set that is floating around?can you play the F:FsToolsRc4winwood99whitepoint05.wav in sound recorder or media player?jd

Hello jd,I haven't installed any additional voice sets after the reinstall. I can play that file in the media player. The file is only 550 bytes and all I hear is a small cracking sound.Rob

launch rcclick debugload a .plnclick start rcclick stop rczip up the log and send it to [email protected]

Hello jd,I examined my directory structure and it turned out that I had a rcv4 directory within my rcv4 directory. I gues I messed things up with the reinstall. I'll do a proper reinstall again and most likely it will be ok than.Thanks for your support sofar, if I still encounter this problem I will let you know.Best, RobBoeing Cockpit Projecthttp://home.hccnet.nl/r.v.d.wiele/

Problem solved!It turned out that when I installed update 4.01 I specified the rcv4 directory, but I renamed that directory to 'RCv4'. The installer of 4.01 put rcv4 behind my specified directory. And I didn't payed attention to that. I removed update 4.01 via de-install and reinstalled it again to the correct directory. Applied update 4.2 and now it is ok.RobBoeing Cockpit Projecthttp://home.hccnet.nl/r.v.d.wiele/