roels21

I reinstalled service pack 1c and fs2crew. Everithing is working fine now. Thnx for help. regards

Ok Bryan, thanks for your help. I will try that out. Roel

Ok thanks. Do you have an other solution for my little problem? Greets Roel

Hello Bryan, Yes i set FSX up to load in 2D cockpit. I have an idea of what i maybe did wrong. Is it possible to use voice control even when button control is activated?

Hello, SInce i have installed the SP1 for FS2crew i get some strange things. I removed the sp1c and reinstalled it. I did not remove fs2crew, but i reinstalled it with SP1. Yesterday I started my flight at EHEH in the 737-700, 2d-panel loaded. I loaded the NGX panel as "short" and started FS2crew with the preflight checklist. During the preflight checklist, Window Heat, I said on and the FO said "are you sure about that". After that he continues on with the checklist. This also happened with the before start flow and before start checklist. I contacted the ground crew via cockpit to ground (response "go ahead"). I said start sequence is 2 then 1. FO response but does not do his flow correctly. After that i cannot contact ground crew for PB and the when i said start engine number 2, the FO said "we are not prepared for that", but everything is setup correctly. I start up by myself and do the pushback via shift-p. After the PB and engine start the FO does not complete the before taxi flow! I do it by myself and call for the checklist and at Probe Heat he says again "are you sure". I call for flaps 5 and FO does turn flaps 5! After that everything works fine until i reach the approach. At the landing checklist "landing gear down and flaps 40 green light" he says are you sure" I also cannot connect the PA via the PA button on the pedestal. I have to use the main FS2crew panel. What is going wrong or what did I do wrong? Thanks for you help already! (sorry for my bad English). Roel Schmitz

I was just taxing out. And a looked at the wings in external view and they did not move anymore. Before sp1c they did move and after sp1c they don't. Is this a bug or has it something to do with the installation of fs2crew?Gr. Roel Schmitz

FMC, descent forecast. On the right you can enter qnh en temperature. But i think it is only for cabin pressure.

I had the same problem. Filed a ticket with PMDG. Problem fixed by:1. loading a new panel state. Do not load a panel state from before hotfix 4.2. reset the brake setting is your fsx config. It fixed my problem. If it not fix your problem, make a ticket on pmdg's website. Greets Roel Schmitz

For me the same problem. After installing Hotfix 4, I made 2 flights and with both landings the autobrakes did not work. Autobrake 2 was set and on touchdown the brakes did not kick in. After that the brakes did not work at all. I never had this problem, but after installing hotfix 4 i have. Roel

I have the same problem with the FMC when i start IVAP. I was setting up the FMC before i started IVAP. Everything was OK.But when i started IVAP, the text in the scratchpad was gone and i had to reload the aircraft to get it back.

I would also love to see a Arkefly livery. It is my favorite airline and the livery is very beautiful. Thank you.