Hey there, first post with a new account. Couldn't get in to my old one. First off I hope this is the appropriate place. I installed EZDok about a year ago and kept putting off actually setting it up correctly since then. Yesterday after seeing yet another video showcasing the head movement effects I decided it was time to bite the bullet and get stuck into those setup videos. Everything is setup correctly and working as intended. The way I fly is with keyboard, mouse and an XBOX controller. Basically I use the controller for hand flying, and have assigned various crucial and commonly used tasks to the buttons, the left thumb stick for pitch and roll and the right thumb stick for panning my view. The ability to pan with the right thumb stick means I can very quickly and accurately flick switches with my mouse in the virtual cockpit, it's essential to the way I fly. The keyboard sits near by with all of the less urgent assignments that you'd expect. As I'm sure many of you are aware, setup of EZDok requires you to unbind some keys and some axis assignments. That's not a problem for the most part, except for my ability to look with the right thumb stick. If you leave this assigned you get the annoying issue of the camera snapping back to centre after a few seconds. So no choice but to remove it. EZDok does provide a panning ability, in the case of my controller with the D-Pad which is effectively a hat switch I believe. I find this method jerky and probably a fair bit too slow for those high work rate phases of flight. So I guess I'm asking two things here. Is it possible to have an axis input in or alongside EZDok or a way to use only the effects? I should point out here that the effects in question are pretty much my sole concern, whilst I like some of the cameras EZDok adds, I have no intention of creating my own. I did make a post over at EZDok's forums, but I've noticed that nobody had posted a thread prior to that for six months or more. Any responses will be greatly appreciated, I'd really like to sort this issue out!