chano777

Hello Every time I move the physical throttle stick (HOTAS X), it doesn´t match the movement of the Thrust Levers in the simulator. By moving them foward to accelerate, I go throug the detents until I reach TOGA DETENT position whitout a problem , the inconvenience is when moving them backwards . For example, at the moment of the "RETARD RETARD" I remove the CLB DETENT thrust levers position for IDLE DETENT position of the simulator but when moving the physical throttle lever of the HOTAS X for its only detent (between the red bar and gray bar), the simulator Thrust Levers do not reach the IDLE DETENT position, but stay at 50.8% of N1 Thrust (See attached screenshots) , I am forced to move the lever of the HOTAS X further back to approximately half the range of the reverse (gray bar)to just be able to place the thrust levers of the simulator to IDLE DETENT position which is uncomfortable during the landing maneuver because there is no detent in that position of the HOTAS X (gray bar) since if I move the stick completely backwards, the REVERSER would be activated in the simulator. When storing REVERSE on the HOTAS X (Single detend between red and gray bar), the thrust levers in the simulator stabilize at 50.8% of N1 and not at IDLE DETENT position. This problem started to happen since I made the axis settings in the FSUIPC to be able to use the reverse in the HOTAS X. When I try to use the simulator whit its own axes and not with the FSUIPC the same problem occurs. I still use FSX. I will appreciate your support. Regards

Hi Al, Your guidance helped me solved the problem and I was able to change the transponder digits. Thank you very much Regards Carlos

I cannot enable the digits in the transponder box. I do the steps by clicking the large black know to enable the first transponder yellow digit but it remains only in dashes when it´s in Stand By mode or in code 1200 when in TARA mode. I uninstalled and reinstalled the aricraft but it has the same problem. I use FSX 32bit. I hope I can find soem solution in this forum Regards