Search the Community
Showing results for tags 'SAITEK'.
Found 3 results
-
Hi there, Recently, i have trouble with my saitek throttle quadrant as it keeps resting to default controls when i start FSX. I have to chnage the settings every single time i restart my FSX. I did not have this problems at all before but i don't know why it happened to me now. Anyone can help me? Thanks
-
Anyone able to assist me with setup of Saitek panels and fips for QOTS. I have regd copies of FUSCIP & SPADNEXT. Youtube videos exist for 737 & 777s but not for 747. Also videos appear to rely on a utility called Linda. 3 different prograns for essentially a few addons seems overly complicated. Thanks Alistair Mcrobert
-
Hello, friends. I have a problem, that I cann not solve without your kind help. The thing is, that I can not assign any functions to my Joysticks and instruments via LINDA. I have P3D 3.x and I operate the Sim with the PMDG 737 NGX. I installed LINDA as reqiured and copied the additional files for the PMDG 737 NGX. LINDA is runnung and the SAITEK Instruments and Joystick, Throttle and the Rudder are listed in the Joystick Setup menu. I switched them all to "Enabled" and saved the configuration. In the LINDA Setup Menu the Saitek Panels are switched on, and the Drop Down Menu above shows the PMDG 737 NGX. In the Configuration list all Joysticks and Devices are shown and the green mesage says "Everything is ok". In case of the fact, that I do not use VRinsight MCP Combo, there are three red messages at the Combo Section: 1. Device disabled 2. COM Port not set 3. No (VRINSIGHT) entry. just right of the red messages is again the green message "Everything is ok!" The next entree shows the headline Flt Sim/ FSUIPC configs Again a green message is on the right site "Everything is ok!" But under the headline there is standing, in red letters: "Flt SIM or FSUIPC is not running. (I do not understanbd why, cause FSUIPC is running, I operate functions with it and it is the full registered version.) And right under in grey letters: "FSUIPC files found" So what is going wrong here, that I cannot assign any functions to the hardware? I am looking forward to your helpulf answers and suggestions. Sincerely Robert