Hello. First post from me, and it is, not surprisingly, a cry for help: Am running FS2002 and have just installed 767PIC and applied two patches that I found on Wilco's very confusing download page. All seems to work well until I try and open any specific flight profile, say, the first delivery flight from KSFO. I get this message: "Aircraft Initialization Failure 767 PIC United Airlines".It then loads and I get a half screen with the upper 50% being a contorted Cessna 172 and the lower half blacked out. When I select the 767 from the aircraft options, I get "Visual Model could not be displayed 767 PIC Wilco Publishing", followed byt the same split screen scenario. What's going on, frustrated minds want to know!

As I recall, there's only ONE patch for FS2002...Go to the PIC Team site at http://www.flightsimnetwork.com/efpanels/ and download the FS2K2 patch.Reinstall PIC.DSCVA3339

Hi,The 2nd patch is only for owners of the Aerosoft 747MCP. Applying this when you don't have that hardware is known to cause problems.Suggest you reinstall and only apply the first patch (to make it compatible with FS2002).Cheers,

Make certain you are applying the -->FS2002<-- patch and NOT the 1.1 patch for FS2000 or you will have issues.J

If you had titled this '767PIC reinstall' I wouldn't have needed to post my request ;) I have just done exactly what you are trying and the answers here give the correct solution.If you only have FS2k2 or do not have 767PIC installed on FS2k as well then:-Install 767PIC to FS2k2 from the CD then run the FS2002 patch and all will be well.Do NOT do what I did and run the earlier 10 to 11 patch before the FS2002 patch it is not required, nor is any other patch; just the FS2002 patch.

Gentlemen,Many thanks for the assistance. I followed your instructions and now am the proud pilot of a perfectly-functioning jet. Am transitioning to the aircraft and am up to my ears in manuals so this was an unneeded malfunction. Hope to be able to contribute to the forum as I gain some real-world experience. Mike.