I used AFCAD221 to move the grass runway at EGLG in FS9 so that it matches the runway shown on my photographic sceneery suiccessfully. However, on creating a flight, the aircraft is still positioned at the end of the orignal default ruway and so is offset from the new one. I've tried;

• dragging the the stock runway
• changing changing the co-ordinates of the centre of the runway by typing them in
• deleting the runway and creating another

After each attempt I deleted AF2_EGLG.bgl to give me a clean start.None worked. What am I doing wrong?

Perhaps you have not changed the Start locations. If so, display them in AFCAD (View - Start Locations), and then it is probably best to delete the default Starts and create new ones.Best regards.Luis

Perhaps you have not changed the Start locations. If so, display them in AFCAD (View - Start Locations), and then it is probably best to delete the default Starts and create new ones.Best regards.Luis

Thank you - that solved my problem!

FYI I found that if it's the default flight then the aircraft start position doesn't change even though the airport is changed with AFACAD!

FYI I found that if it's the default flight then the aircraft start position doesn't change even though the airport is changed with AFACAD!

That is because it is a stored flight. Create a new flight by starting at the new start and save that as the default