September 17, 200916 yr Hi I have saved a cold and dark situation. If i load the situation and i engage the fuelpumps the engines are running up without a ignition sequence and the conditionlever are in TAXI position. Whats wrong?
September 17, 200916 yr Hi I have saved a cold and dark situation. If i load the situation and i engage the fuelpumps the engines are running up without a ignition sequence and the conditionlever are in TAXI position. Whats wrong?Make a default flight with the FSX 172 and everything turned off. Use this FSX state to load your saved flight state with the J41. This is the sequence that gives me the best consistency and will ususally give me all the saved conditions of the ramp manager as well. Hope it helpsJB Buzz313th
September 17, 200916 yr Before you start the engines, have a look at the props... if they are feathered, then you don't have the start locks engaged... you don't want to start these engines without start locks engaged...If the props are feathered, you will need to pull back the power levers into reverse, then one by one unfeather the props fully using the unfeather switch on the central console below the power levers...Andrew Andrew Entwistle
September 17, 200916 yr Make a default flight with the FSX 172 and everything turned off. Use this FSX state to load your saved flight state with the J41. This is the sequence that gives me the best consistency and will ususally give me all the saved conditions of the ramp manager as well.Ok, i have load a default flight with cessna and the flight is cold & Dark. If i change the Aircraft. The Jetstream is powerd up by battery attention getter illuminated and strobe and NAVlights in position on.'Thats not a realy Cold &Dark position such with the FSX Cessna 172.@aentwis: THX, for this...
September 17, 200916 yr Ok, i have load a default flight with cessna and the flight is cold & Dark. If i change the Aircraft. The Jetstream is powerd up by battery attention getter illuminated and strobe and NAVlights in position on.'Thats not a realy Cold &Dark position such with the FSX Cessna 172.@aentwis: THX, for this...Thats normal... now after you have selected the J41 after initialising the flight from the default 172 state, now shut down all the systems on the 41 and save the state title My J41... Now reload the default 172 default state and then directly from there load your "My J41" saved flight. When the J41 loads it should be in the exact state that you saved it in...JB Buzz313th
Create an account or sign in to comment