HelloI am still in the learning phase of this wonderful PMDG aircraft.I have still two remaining issues:1/ Even following the tutorial and make a lot of searches, I can not get any information written on the EADI and EHSI...????They are powered but no information appears whatever speed, altitude, heading, course.....I tried different config and different refresh speed...2/ With a registered FUIPC I assigned and configured 2 axis for the throttles. But when I push the 2 throttles full forward, only one of them goes forward, the second one nearly remain at the same placeThanks in advance for your advisesPascal

Your first issue is probably due to the fact that they need to "spin up" before they'll give you any information. It is mentioned in the manuals, along with the fact that you can use the knobs to select a position that essentially shows a countdown until they're ready.Having just looked at the tutorial, the information above is mentioned on page 18/19 (and it also references the AOM). Perhaps you should retry the tutorial, and take a look at the AOM pages it references.

If they are completely blank, then your registration may have failed.

Many thanks pour your replies.I re-installed the JS41 and the point n°1 is ok now ?!! = closedfor the point n°2, in fact I did not see the gust lock so now with the gust lock desengaged it is ok. = closedI am using the LUA file in order to start cold and dark and I just noticed that in this case, the column FLCS is blocked.I don't know yet how to make it moving again but I am reading the OAM Manual ;-))I'll keep you updateThanks againPascal