Jump to content

Archived

This topic is now archived and is closed to further replies.

CathyH

Autopilot Will not engage

Recommended Posts

On the Wilco 737, I normally go toautopilot on the climbout at about 1800ft. No matter waht I do I cannot get the autopilot to engage on the FSX Ifly 737, any model. Not sure waht, if anything I am doing wrong, help, please?

Share this post


Link to post
Share on other sites

Just like the real thing, the aircraft must be trimmed before the AP will engage. Also, this model is sensitive to yoke noise. Make sure you have a good yoke dead zone and the yoke sensitivity slider is turned way down in the Ifly config. You can test by giving the keyboard command that disconnects the yoke during fight to see of the AP will engage. I forget what the command is.

Share this post


Link to post
Share on other sites

If you are having problems registering for the official support forum, please contyact Flight1. This forum is NOT for support on the iFly 737NG.

Share this post


Link to post
Share on other sites

×
×
  • Create New...