MilViz T-38A Thread?

CHANGE LOG:08/16/11=========1. Restored original pilot figures 2. Fixed the hesitating main wheels CHANGE LOG:08/12/11========= 2. Updated the exterior texture for inside of the engine intakes on all liveries. 3. Modified code to inhibit speed brake extension with no hydraulic pressure. 4. Added safety wire on pilot's left side console for the engine trim adjusters. CHANGE LOG08/05/11=============1. CN2 >100% *AND* power lever position > 85% to trigger the AB's. I've also set AB off to be CN2 < 100% *OR* power lever position < 85%. 2. I've also modified the "clack" sound to play in both directions. IOW, when leaving AB you will hear a "clack" to let you know you're back at MIL power. 3. I've also added some "time of day" checks to reduce the AB "flames" during the daytime. 4. Installed Chuck's animated pilots. 5. Updated the T-38A's external sounds with Fabio's revised .wav files. CHANGE LOG:07/31/11=========1. Added missing aft panel mesh for the exterior model. 2. Add limit code to the slip indicator. 3. Removed visor shadows from the Thunderbird pilot's helmets. CHANGE LOG07/27/11---------------1. Includes Bernt's latest FDE (A3) 2. Includes latest Macro files 3. Fixed the COM radio tuning, expanded tooltip to show all three decimals 4. Fixed the two yoke buttons that were "floating" 5. Moved the fwd mirrors to the canopy frame in exterior and interior models 6. Shifted the audio rumble sounds 0.1 unit "ahead" to delay onset of "massive rumble" just above 0.6 units. CHANGE LOG07/23/11---------------1. YD Switch is now just a dummy, it moves and makes noise. 2. Reversed animation for the Speedbrake slider; installed same slider in aft cockpit. 3. Positively lock nose gear steering when wheels off ground. 4. Fixed shroud in aft canopy mechanism 5. Anti-Ice system now operative and fixed tooltip 6. CRS knob's tooltip will now indicate correct degrees based on mode switch (OBS1, OBS2) CHANGE LOG07/20/11==========1. Helmet Visors are "up" at night/dawn/dusk, "down" during daytime. Removed the "shadows" from the standard white helmet texture. 3. Cloned fwd AoA needle for aft panel. 4. Disabled "Yaw Damper" while on ground. If 3d switch is "on" the sim command for "Yaw Damper" is activated. 5. Installed Bob's revisions to the Gear Warning and extend/retract logic, updated trimmed gearup.wav file, revised aircraft.cfg extension times for gear. 6. Installed Bob's revised "Buffet Sound" and "Buffet System" logic. Tests fine for me here. I have of course retained the original logic, "just in case..." 7. Reworked the fwd speedbrake control to make it a "slider" rather than a "rocker." If this is okay, then I'll clone/past to the aft control as well. 8. Brightened the exterior model's lightmap for the panels so they can be seen through the canopy glass. CHANGE LOG07/17/11===========1. Multi-Player now works correctly. It is no longer flooding the server with repeated events. 2. Afterburner System should now be SP2 complaint. 3. Modified Gear Warning to use %N1 rather than power lever. 4. Cross-Feed System now working correctly. Shift-4 to bring up a digital test gauge to verify if you like. This will be removed from the release of course. 5. Fuel Flow needles on aft panel now working properly.