Jump to content

Archived

This topic is now archived and is closed to further replies.

diver3024

HIGHMEMFIX question

Recommended Posts

Not sure if I did this rite. I followed PMDG's instructions and added the "HIGHMEMFIX=1" to FSX.cfg. When I did this, there was an existing line there already but it says something like "HIMEMFIX=1". Now, was I supposed to edit the existing "HIMEMFIX=1" to "HIGHMEMFIX=1", or just add the suggedted "HIGHMEMFIX=1 and leave the existing "HIMEMFIX=1 there as well. Thanks.

Share this post


Link to post
Share on other sites

Just finished the tutorial, landed everything running well, changed time from day to dusk while taxiing, and lost most textures, see-through cockpit etc. Went to check fsx.cfgand found that at the exact time I did the time change the HIGHMEMFIX=1 had been replaced by "HIMEMFIX=1".

Share this post


Link to post
Share on other sites

Replace HIMEMFIX=1 with HIGHMEMFIX=1.This is a trick I used in my ARMA 2 .Cfgs, but try switching the files to Read-Only, so FSX Cannot change it back.

Share this post


Link to post
Share on other sites

HELLO,i done what was said by ******* on his site, he changed the cfg i then put in everything as per instuctions, and going back just now after reading above the cfg in fsx has changed back to what it was before? not only that i now have one with just fsx and another with fsx.CFG both with the same contents....the originals.. james.

Share this post


Link to post
Share on other sites

×
×
  • Create New...