Jump to content

Archived

This topic is now archived and is closed to further replies.

cubs

problem with flight controls in FSX

Recommended Posts

I just installed windows 7 and I am running FSX. It runs beutiful !, but there are problems. I have the PMDG 737NG, PMDG 747-400, CS 707. I am also using EZDOK. I use FSUIPC to control the landing gear, flaps and views on the hat switch and I use the default settings through FSX to operate my CH peddels, throttle quad, and yoke. One day it works great and the next day, nothing works. If I reconfigure it, shortly after I will get I think is a CTD. my computer screen starts to go grainy and I loose control of it. I end up pulling the plug to power it off. Not good. Any suggestions would be helpful, thanks Doug Morlan


Douglas Morlan

Share this post


Link to post
Share on other sites
I just installed windows 7 and I am running FSX. It runs beutiful !, but there are problems. I have the PMDG 737NG, PMDG 747-400, CS 707. I am also using EZDOK. I use FSUIPC to control the landing gear, flaps and views on the hat switch and I use the default settings through FSX to operate my CH peddels, throttle quad, and yoke. One day it works great and the next day, nothing works. If I reconfigure it, shortly after I will get I think is a CTD. my computer screen starts to go grainy and I loose control of it. I end up pulling the plug to power it off. Not good. Any suggestions would be helpful, thanks Doug Morlan
HelloReconfigure through Fsuipc and disable the FSX joystick controls, Fsuipc will do a much better job of calibrating and setting up your all your axis.You will also have the benefit of the profiles function.Mixing the two is most likely where your problems stem from.

Share this post


Link to post
Share on other sites

×
×
  • Create New...