Hi Geof,My nav lights were ok, but I did find and anomoly in the F33 Bonanza. The wheel doors won't close with wheels up. I just happened to jump ut of the plane while I was flying, (I seldom do this), and lo' and behold', the doors were open, wheels were up OK but doors stayed down. Have you had this? Maybe I'll try to Batch convert in PlaneMaker to see if that makes a difference.

Nope -I don't have that one at all. I am a little afraid to convert it in PlaneMaker (I thought about the same thing for my problem) as I don't want the flight dynamics to change....or is that an irrational fear?

If I may please,I have the same Issue with the "wheel doors" staying open, didn't notice this before.I had the prop issue ONLY when I changed aircraft, or changed any rendering settings, but re-started the sim all was fine.I'll just wait for the fix, Beta 4 is due out today, it may clear a few of these issues up.

Nope -I don't have that one at all. I am a little afraid to convert it in PlaneMaker (I thought about the same thing for my problem) as I don't want the flight dynamics to change....or is that an irrational fear?

LOL Not irrational at all. I went into planemaker, no joy but it didn't seem to hurt anything either. It still flies about the same. 25hg, 2500rpm it does about 170 kt. level. Takes a lot of aileron trim in my setup but so does everything. Take off trim I put at the U above the zero and it lifts off at about 90 kts, So seems about the same. Does that trim level seem about right to you?Probably over time, we'll find other little things, but that is the way of the sim world. Wonder if the Air Force is constantly tweaking theirs. :-)By way of the prop anomaly, I get one after a hard crash. I have to reboot then. If I close the sim in the middle of a flight with out landing first, when I start the sim back up, the plane falls out of the sky, crashes and then no sound and I get a prop anomaly. So close the sim then restart with the plane on the ground, and everything is OK again. I get that with about all the planes though. May be a bug, but I don't see that its worth worrying about.

LOL Not irrational at all. I went into planemaker, no joy but it didn't seem to hurt anything either. It still flies about the same. 25hg, 2500rpm it does about 170 kt. level. Takes a lot of aileron trim in my setup but so does everything. Take off trim I put at the U above the zero and it lifts off at about 90 kts, So seems about the same. Does that trim level seem about right to you?Probably over time, we'll find other little things, but that is the way of the sim world. Wonder if the Air Force is constantly tweaking theirs. :-)By way of the prop anomaly, I get one after a hard crash. I have to reboot then. If I close the sim in the middle of a flight with out landing first, when I start the sim back up, the plane falls out of the sky, crashes and then no sound and I get a prop anomaly. So close the sim then restart with the plane on the ground, and everything is OK again. I get that with about all the planes though. May be a bug, but I don't see that its worth worrying about.

I don't know where I read this, but it seems there is a problem with trim. Apparently, trim will not work for the full cycle. It goes neutral and all the way up or the opposite. This could explain the difficulty adjusting for aileron trim.

I haven't noticed too much of the trim thing-but both my Deb and Baron would only give 27 inches on takeoff and loose an inch for every thousand feet you go up-and this doesn't seem to happen....