Color me dense, maybe this is a dumb question. How do you get it to start? I click on "enable voice control" It tells me it is enabled I start FSX and click on the spot that starts the main panel. It tells me FSCrew started. But then it just sits there and says pre-flight I can give a voice command like "start again" and the FO responds OK. but nothing happens. I am using the start state Short. The plane is powered up but engines not running. I never see the timer. Any help would be appreciated. Jerry

I always start cold and dark so I dont know if this is the answer, but the flow has to be in the corresponding condition for which your plane is. Is the plane powered? If so, click on the arrows on the FS2Crew panel until it says "Before Start" [ if engines not running ] or "Before Taxi" [ if engines are running ] then follow the flows for that section. If your in the wrong flow for a particular aircraft state, the FO will never respond to commands.

Color me dense, maybe this is a dumb question. How do you get it to start? I click on "enable voice control" It tells me it is enabled I start FSX and click on the spot that starts the main panel. It tells me FSCrew started. But then it just sits there and says pre-flight I can give a voice command like "start again" and the FO responds OK. but nothing happens. I am using the start state Short. The plane is powered up but engines not running. I never see the timer. Any help would be appreciated. Jerry

Hi Jerry,Please take a look at the manuals.Link for them is available via the NGX Config Manager.The "Flows" are central to understanding this product. Also look at the "Quick start guide"Cheers,