When I activate the reverse thrust, I see on the eicas that it is in reverse, outside I can see the engine in reverse, but I hear no sounds until I pull the reversers back to idle. Shouldn't I hear a constant reverse sound? I hear it in the 747

 

-David

Anyone else with this problem?

It seems a missing file, so try to reinstal.

But before it,

-try another panel state

-read the intro manual and try to set all volumes in fsx and FMC to the correct values.

If doesn't help, it is a file problem.

there's a thread here in the ngx furom of a new reverse sound, try those and see if you can hear it.

Sounds like you need to increase the throttle further once in reverse..

There is nothing wrong with the current sound.. But you won't hear it if

you throw it in reverse, but don't bump up the throttle after it's in reverse..

That's my theory anyway.. I know when I go into reverse, I have to continue

to tap the reverse throttle "F2" a bit until the throttle is run up and it kicks in..

Then as I approach 60 knots, I'm slowly lowering it back down with "F3", and

at 60 knots, I kill and stow it with "F1".

I use fsuipc to map reverse thrust for my ch products throttle quadrant. works fine in every other aircraft, move the throttles all the way back and reverse thrust engages. i just don't hear the sounds in this airplane.

Pretty strange.. I hear them here.. Do you see the N speeds increase, etc when you advance

the throttle while in reverse?