Fellow Captains,

 

After reinstalling the NGX due to a HDD crash I discovered that the yoke in teh NGX is limited to about 15%. I am using the G940 flight set from Logitech using the latest drivers and a full calibration in FSX. But either using my G940 or the keyboard, none will move the yoke more than 15%. The NGX is set up with hydraulics on etc so it should work. I also tried other planes by they do work properly. The yoke is not limited as it is in the NGX.

 

Could anyone help me out here or is a reinstall needed?

Thanks in advance!

Check the controls' sensitivities within FSX and set them to max.

Already done but with no succes..

Are you processing the axes through FSUIPC or anything like that?

No, I just have the freeware version of FSUIPC. Before the reinstall there were no problems as they are now.

Hello Maarten

 

I find this yoke situation is corrected by having all 4 hydraulic switches on with the GPU or engines running...also sometimes the yoke axes need resetting, but I use FSUIPC (full) for all my controllers and buttons.

 

Cheers, Bruce

I tried switching on the pumps with the GPU running. The plane flipped over and crashed.... Since then every single time I load the NGX the aircraft flips over and crashes.

 

I guess the installation is corrupt and I am reinstalling the NGX. More to follow!

Sounds like a controller setup issue. I had a problem with my rudder pedals causing my planes to flip over as you describe - turns out some FSX axes had been changed, resetting all the controller setup worked a treat.

Hey there all, after a very nice holliday I decided to reinstall the NGX and guess what happend. All the problems mentioned above have disappeared and the time needed to startup FSX are half as long as before. I guess I can say the installation was corrupt....

 

Thanks you all for putiing in feedback!