Jump to content

Archived

This topic is now archived and is closed to further replies.

Drew_Melia

reinstalling

Recommended Posts

If I wanted to re-install the NGX range - 600 thru 900... to SP1c standard, whats the procedure? I have all the executables since the original release including the hotfix, SP1, SP1b and SP1c.

Share this post


Link to post
Share on other sites

I recently did a fresh install and asked the same question :wink:

 

The recommended procedure (that worked for my anyway) was:

1. 8/900 Base Pack

2. 8/900 SP1c (because the service pack is the prerequisite for installing the 6/700)

3. 6/700 Extension

4. 6/700 SP1c

Share this post


Link to post
Share on other sites

I recently did a fresh install and asked the same question :wink:

 

The recommended procedure (that worked for my anyway) was:

1. 8/900 Base Pack

2. 8/900 SP1c (because the service pack is the prerequisite for installing the 6/700)

3. 6/700 Extension

4. 6/700 SP1c

 

I don't think there's even an alternative way to do it.

Share this post


Link to post
Share on other sites

Interesting> i followed the instructions perfectly and find that I am now unable to scroll through the various windows any longer. Just the captains VC view. are there any specific settings that will enable me to scroll using the "A" key to the second officers view?

 

thanks

Mel

Share this post


Link to post
Share on other sites

Mel,

 

Do you happen to use EZDok? If so, make sure to run EZCA Config whenever you install/reinstall an aircraft.

 

Hope this helps,

Stefan

Share this post


Link to post
Share on other sites

×
×
  • Create New...