If I wanted to re-install the NGX range - 600 thru 900... to SP1c standard, whats the procedure? I have all the executables since the original release including the hotfix, SP1, SP1b and SP1c.

I think sp1c is the last and the only one you need, no hotfix and prcedent sp.

I recently did a fresh install and asked the same question

 

The recommended procedure (that worked for my anyway) was:

1. 8/900 Base Pack

2. 8/900 SP1c (because the service pack is the prerequisite for installing the 6/700)

3. 6/700 Extension

4. 6/700 SP1c

I recently did a fresh install and asked the same question

 

The recommended procedure (that worked for my anyway) was:

1. 8/900 Base Pack

2. 8/900 SP1c (because the service pack is the prerequisite for installing the 6/700)

3. 6/700 Extension

4. 6/700 SP1c

 

I don't think there's even an alternative way to do it.

OK, thanks guys....I'll follw Stefan's procedure.

 

:Peace: :im Not Worthy: :good:

Interesting> i followed the instructions perfectly and find that I am now unable to scroll through the various windows any longer. Just the captains VC view. are there any specific settings that will enable me to scroll using the "A" key to the second officers view?

 

thanks

Mel

Mel,

 

Do you happen to use EZDok? If so, make sure to run EZCA Config whenever you install/reinstall an aircraft.

 

Hope this helps,

Stefan