Jump to content

Archived

This topic is now archived and is closed to further replies.

Piper9t3

EzDok External Camera View Anomaly

Recommended Posts

Hello everyone

Recently purchased the F33 and after configuring all my EzDok camera views I get an external camera view as shown below:

 

 

 

Can anyone suggest a fix for this anomaly? In addition, if anyone has set up some EzDok camera files for the F33 please do share. Much appreciated!

 

John

Share this post


Link to post
Share on other sites

Yes...use an 'aircraft' view instead of a 'cockpit' view (middle column). You'll like it better. :)

Share this post


Link to post
Share on other sites

Yes...use an 'aircraft' view instead of a 'cockpit' view (middle column). You'll like it better. :)

 

I have configured all my camera views as per attached EzDok studio screenshot:

 

 

 

 

My Virtual Cockpit views (left studio column) are all good when I switch to the Aircraft views (middle studio column) I get the problem as can be seen with "Tail" view above.

Are you saying configure all my views in the Aircraft column?

Share this post


Link to post
Share on other sites

Are you saying configure all my views in the Aircraft column?

 

No. When you use the middle column you should get the complete aircraft. The only reason you might not is if the camera is too close to the aircraft. Other than that, I'm not sure what might be going on.

Share this post


Link to post
Share on other sites

After you install each new aircraft, you have to run EZdok's Aircraft Configurator Tool and click on the "Configure FSX" button.

 

... and that's all you have to do: when the program finishes configuring, just exit it. From that point forward, your aircraft should look normal.

Share this post


Link to post
Share on other sites

×
×
  • Create New...