Archived

This topic is now archived and is closed to further replies.

Raptor05121

Possible to add a gauge?

Recommended Posts

I L-O-V-E the C337 and its panel (and how Carenado made the gauged 3D by including them in the model) but I'm curious if its possible to add a gauge? I just wanted to add one simple digital fuel burn gauge to the very right-hand side of the panel, where there is an available spot.

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Sure, at least on the concept side. What's sometimes blocking those attempts is the 3D model of the plane. It may, at times, be 'above' the new gauge you've placed in the panel, so it doesn't show up.

 

Best chances are at a flat surface, perhaps even by replacing another (somehow flat) gauge. Just make a copy of the panel.cfg and try it. For the other folks, perhaps post some screenshot on where you think it would fit.

 

And, if you are just looking for a gauge as a popup, this always works.

Share this post


Link to post
Share on other sites

The 3d model blocks pretty much the entire panel, except for some small windows,

used for the radio readouts, the DME, and the engine analyzer.

 

If you can think of a way to add the readout you are after to the engine analyzer

gauge, I can likely help you with that - but the right hand side of the panel is not

accessible, I am afraid.

Share this post


Link to post
Share on other sites