SP1c installed now I only see wings on outside view

[StevenHiga 0]

I just updated to SP1c on the NGX. Now all I see is the wings and a PMDG 'box' where the front of the plane is. Cockpit view is good, plane flys normally. But when I switch to outside view it only show wings. I removed the Britsh Airways paint and re-installed it but it did not help, the stock PMDG 900 winglets are the same. I had to taxi like this. :(

 

I don't want to re-install as I just set everything up. I've re-installed the BA Paint 3 times, no joy.

 

Any help appriciated

 

Thanks

 

Speedbird 536

 

Steve Higa from Oxford UK

[pete_auau 1,176]

I take it you have the highmenfix=1 in your fsx.cfg if you have than try lowering your sliders down abit other than this i got no other ideas

[XCLTM3 112]

Hi Steven,

 

do you happen to use EZDOK? (ie EZCA).......if so, you need to run the config for EZDOK again before starting FSX. Once you've done this, the external view will be ok again.

 

Rgds,

 

Steve

[Tabs 2,790]

Hi Steven,

 

do you happen to use EZDOK? (ie EZCA).......if so, you need to run the config for EZDOK again before starting FSX. Once you've done this, the external view will be ok again.

 

Rgds,

 

Steve

 

Very likely this - SP1c overwrites the aircraft.cfg files. You need to rerun the EZCA config to readd the camera definitions to it.

[StevenHiga 0]

Thanks folks your amazing, spot on. I can see everything now. Phew, no need to re-install :rolleyes: Now to work connecting 2nd computer to run Navigraph and sqwaukbox, fingers cross.

 

Cheers Steven Higa from Oxford

 

Speedbird 536