I'm on page 53 of the tutorial 2 manual. For the FO's flows I looking at the hydraulics for FLT CONTROL. The tutorial shows the LOW PRESSURE lights to be off. In my sim they are on, along with fuel pressure being low on page 55.

 

I've followed the tutorial to a T to this point. What did I do wrong? Here's a pic of my overhead reaching Page 53 of tutorial #2:

 

What did I do wrong?

 

Nothing, manual is wrong.

 

EDIT: Opened manual:

 

at page 55 screenshot is wrong, but text is ok

Verify that all six FUEL PUMPswitches are off and the center

tank LOW PRESSURE lights are extinguished and the main

tank LOW PRESSURE lights are illuminated.

 

at page 53 screenshot is also wrong, but there are not appropriate text to describe situation.

Ok, so for the following pages where its showing the lights extinguished and mine are ON I should still continue? Or was this just a bug with the tutorial?

I just have a quick look at tutorial2.pdf, and it seems majority of screenshots are just for reference purpose, they do not represent a panel state for flow, which is a shame. So just continue to read text and do not pay attention at screenshots.

Alright thanks!

For completeness' sake: the electric hydraulic pump low pressure lights will extinguish after you switch on said electric pumps as part of the Before Start Procedure. The engine-driven hydraulic pump lights will go out after you start each corresponding engine.

For completeness' sake: the electric hydraulic pump low pressure lights will extinguish after you switch on said electric pumps as part of the Before Start Procedure. The engine-driven hydraulic pump lights will go out after you start each corresponding engine.

 

Kinda hard to have pressure when the pumps arent turnin. Old farm boy!