The title almost says it all, I was doing a flight from LFPG to OMDB using time accelaration, the problem is that the exterior just start bugging from time to time like the engines exterior texture and the Wings, flaps and tail section would be black or grey before coming back to normal, to finally after that being all invisble as if their where no texture and I could see the whole interior because of that. Would like to know if this could be fix ? I was using FSX Sp2, Active Sky 2012 SP2, PMDG 777-200LRX Air France Livery.

HIGHMEMFIX=1 in the FSX.cfg?

HIGHMEMFIX=1 in the FSX.cfg?

Done Allready, so I don't think that that's the problem.

Done Allready, so I don't think that that's the problem.

 

Well you didn't state that, and that's an important first check, so I had to ask...

 

Does this only occur in time acceleration?

I would most likely say yes. Cause Last time I used the PMDG777 it didn't do that but for that flight I Hadn't used time accelaration so I guess I can say yeah only when I use Time accelaration. (If I may add, last time's flight was around 7h30/40min flight time. For this one it's around 7h20/30min flight time so the time difference for the lengh of these to flights are almost simular.

Apart from the HIGHMEMFIX thing, I don't have much experience with any of this, so hopefully someone else will be able to chime in.  My guess is that the accel is causing your computer to run out of resources to render everything.

I sure hope so too !

Yes  don't  go above  4x  in  time  accel  or  you find  you have these  issues

I did my flight without the time accelaration and yet I have the same problems.. can someone help please ?

Sill no one ?

think  it  the textures loading  trying  to catch up, try sliding  down your  settings  see if  that fixes  it  start with the autogen  first