Hello

As can be expected for some addon airports, I have been experiencing airport scenery anomalies with the DX10 fixer.  The anomalies don't immediately appear when I load my aircraft but after about 3min or so the airport aprons/taxiways and runways turns in to a reflective ice rink.  It is difficult to explain so some screen shots below will illustrate the problem.  These are from FlyTampa's LGAV.  I have also had it happen with other dev payware airports as well.  Is there anyway to correct this?  I am reluctant to approach the devs since a lot them do not offer DX10 related support. 

 

 

 

 

 

 

Fixed with the upgrade, John - git on over to FSS and download a fresh copy: it's a new version.

 

Un-install the libraries of the old one, then install over the top - ok!

pj

Thanks Paul.....seems like the new build has corrected the problem.  :yahoo:

Hi Paul

Looks like this problem has re-occurred for me. This time at LH simulations Budapest airport which I recently purchased. FSX time was set to Dawn. I get reflective ice rink effect on aprons/taxiways/runways. I have updated DX10Fixer tool to version 1.3. Is there any specific setting(s) that needs to be tweaked to prevent this from happening?

Fixed with Version 1.0, Build 19, John.

 

Did you run the Fixer again after you installed the airport?

 

Lastly - 1.4 is now available at FSS, so you might try a re-install, using the default settings, (plus ticking the three boxes at the beginning).

 

pj

Try moving the legacy slider to the left, it's possible that if the surface has a transparency and a specular component that the tool will guess wrong if the slider is in the middle position.

Thanks fellas...Ver 1.4 installed and legacy slider full left  fixed the problem at LHBP. 

Thanks, that also works for the new Aerosoft LGTS