Cautions when landing

[CaptainLars 21]

Sorry to be "hijacking" this, but how can I trigger the display of the "lesser" engine values like FF and N2 on the primary EICAS as well?

[CaptainLars 21]

I'm sure it's somewhere deep down in the manual, but perhaps someone knows this out of memory?

[Budbud 227]

Hello,

 

As far as I know, you cannot change what is displayed on the upper EICAS regarding engines values. However, you can see these values on the lower EICAS by selecting ENG on the EICAS control panel.
You may confuse with the NGX where you can have all the values on the upper EICAS by pressing twice the ENG button.

[CaptainLars 21]

Hello,

 

As far as I know, you cannot change what is displayed on the upper EICAS regarding engines values. However, you can see these values on the lower EICAS by selecting ENG on the EICAS control panel.

You may confuse with the NGX where you can have all the values on the upper EICAS by pressing twice the ENG button.

 

Hi,

 

I'm referring to this:

 

Just did an autoland into WSSS. Terrain warn was still screaming at me.

 

[Budbud 227]

Ok,

 

I'll check next time I do a flight with the T7.

[KevinMM 22]

The amber message says "Landing Altitude." Did you set up your FMC?

[pcubine 143]

but how can I trigger the display of the "lesser" engine values like FF and N2 on the primary EICAS as well?

Below the ND is a switch that has EICAS as its right most position. Right click the switch until the line on it lines up with EICAS. Go to Control Selection Panel and left click the two most upper left buttons. Return to the original switch and left click it twice making sure it line up with NAV. The compact display will appear then.

[CaptainLars 21]

Below the ND is a switch that has EICAS as its right most position. Right click the switch until the line on it lines up with EICAS. Go to Control Selection Panel and left click the two most upper left buttons. Return to the original switch and left click it twice making sure it line up with NAV. The compact display will appear then.

  

It works! Thank you very much.

 

The amber message says "Landing Altitude." Did you set up your FMC?

 

Not my screenshot!