November 25, 20169 yr Sorry to be "hijacking" this, but how can I trigger the display of the "lesser" engine values like FF and N2 on the primary EICAS as well? Regards Lars Wüst
November 30, 20169 yr I'm sure it's somewhere deep down in the manual, but perhaps someone knows this out of memory? Regards Lars Wüst
November 30, 20169 yr Hello, As far as I know, you cannot change what is displayed on the upper EICAS regarding engines values. However, you can see these values on the lower EICAS by selecting ENG on the EICAS control panel.You may confuse with the NGX where you can have all the values on the upper EICAS by pressing twice the ENG button. Romain Roux Avec l'avion, nous avons inventé la ligne droite. St Exupéry, Terre des hommes.
December 1, 20169 yr Hello, As far as I know, you cannot change what is displayed on the upper EICAS regarding engines values. However, you can see these values on the lower EICAS by selecting ENG on the EICAS control panel. You may confuse with the NGX where you can have all the values on the upper EICAS by pressing twice the ENG button. Hi, I'm referring to this: Just did an autoland into WSSS. Terrain warn was still screaming at me. Regards Lars Wüst
December 1, 20169 yr Ok, I'll check next time I do a flight with the T7. Romain Roux Avec l'avion, nous avons inventé la ligne droite. St Exupéry, Terre des hommes.
December 1, 20169 yr The amber message says "Landing Altitude." Did you set up your FMC? Kevin M. Manley
December 1, 20169 yr but how can I trigger the display of the "lesser" engine values like FF and N2 on the primary EICAS as well?Below the ND is a switch that has EICAS as its right most position. Right click the switch until the line on it lines up with EICAS. Go to Control Selection Panel and left click the two most upper left buttons. Return to the original switch and left click it twice making sure it line up with NAV. The compact display will appear then. Michael Cubine
December 1, 20169 yr Below the ND is a switch that has EICAS as its right most position. Right click the switch until the line on it lines up with EICAS. Go to Control Selection Panel and left click the two most upper left buttons. Return to the original switch and left click it twice making sure it line up with NAV. The compact display will appear then. It works! Thank you very much. The amber message says "Landing Altitude." Did you set up your FMC? Not my screenshot! Regards Lars Wüst
Archived
This topic is now archived and is closed to further replies.