Hello everyone: Maybe happen to you before and I need your help.

 

I have been trying to complete and follow the tutorials include it and I am having problems finishing the tutorial # 2 on page 66 ..."verified that auto fail and off sched descent lights are both extinguished.. " the auto fail still on from the point I cant enter our planned cruised altitude and the land altitude on the pressurization panel from the point I havent been able to complete the tutorial witch not able to setup the MCP etc. The autopilot is not available and everything else that goes with it. I think I start noticed problems as soon as I complete the part of the tutorial that request to disconnect the ground connection. from the point I getting lost on the tutorial and not able pass troughtout.

I have been following the tutorial carefully to expect good results and with not success twice already.

If you can direct me or help me what Iam doing wrong.

 

Your help will be apreciated.

 

Thank you 

 

Cesar Martinez

Hi I need help trying to complete tutorial # 2 I noticed that the auto fail light is on all the time and not able to shut off, also when I ignore that part at the end the MCP is blank and not able to enter setting to complete tutorial. Any sugestion what I did wrong. I have been following the tutorial carefully twice and still same results. I think I am start losing control when on the tutorial call for CDU , fs actions ground connections to remove ground power and the air conditioning unit.

 

If you have same problem I would like to hear your coments.

 

thank you very much

 

Cesar Martinez

On page 60 did you...

 

1. Start the APU?

 

2. After APU start, did you put the APU generators on the bus?

 

If you did not complete those two steps, then when you disconnect ground power you will back to only battery power, and many systems will power down.

 

Dave