Hello Guys!

 

I recently wiped out my PC and did a fresh Windows 10 install. So far it has been great with FSX and all add ons I use BUT:

 

It is now when I actually fly my 777 for more than 15 minutes for testing, so about 4 hours in to my first flight, while on cruse I noticed that the textures for the engine when I went in to the wing view were just not there, the engine was but the paint was not I was only able to see the pylon not painted, then it turned black, then my FPS went really low (2-3 FPS average) then on the cockpit all my knobs dissapeared and parts of the panel went black. Now please note this all happened gradually.

 

Las time I had something similar I was missing the HighMem fix on my CFG file but I check and it was there

 

I did not run FSX as an admin (as I never do) so I rebooted my PC and ran FSX as admin and I am currently testing, just took off and put the AP on cruise to see if I can replicate this, but wanted to reach out and see if someone had experienced this before and maybe help?

 

Thanks in advance!

 

Danny.

 

System:

 

AMD 9590

16gb RAM

Windows 10

GTX750i

 

FSX Add Ons:
 

FS2crew

PMDG777

EZdok

Trackir

Cielos ATC

ASN

Rex 4.0

 

 

Is your version of windows 10  64 bits?

Maybe you upgraded from a earlier version of windows which was 64 bits to a windows 10 32bit version.

In this case the amount of VAS available would drop from 4gb to 3gb hence the issue with textures loading?

I think windows 10 automatically installs with the same architecture. So it can't revert to 32 bit from 64 bit. I suspect running FSX as admin is the key here. Not running as admin is bound to cause problems.

Thanks both for the ideas and for responding. I have been running FSX as admin and so far so good (Fingers crossed)