October 14, 20169 yr Some of you might have already noticed the RXP GTN v2.2.x already includes support for the TX/RX flags when using the PilotEdge ATC plugin. You might have also noticed the TCAD picks up the other aircraft flying around you! In the next update, the RXP GTN will also include support for controlling the X-Plane COM and NAV audio volumes, along with the latest PilotEdge ATC datarefs. This shall give you a seamless experience on their network!
June 1, 20206 yr I did a quick test of Tcad in pilotedge and it didnt seem to show any traffic. I was on the ground, so maybe it doesnt work there. I have Ryan TCAD enabled. Anything else I need to do? thanks in advance Paul
June 2, 20206 yr Author Hi, Yes, you might want to read the RXP GTN User's manual and everything related to 'traffic' or 'tcad', in the "Settings" chapter. There is more than just 1 setting for this to work!
June 2, 20206 yr 2 hours ago, RXP said: Hi, Yes, you might want to read the RXP GTN User's manual and everything related to 'traffic' or 'tcad', in the "Settings" chapter. There is more than just 1 setting for this to work! Thank RXP. Got it to work. It was the Us AI Traffic only tab. When I unclicked it worked. Paul
June 6, 20206 yr How about getting the 3rd digit after the decimal on the radio to show up? Anyone figure that out? Or is it obvious and I'm just not seeing it? When I load the plane I see 3 digits but when I try and tune a frequency I only get 2??
June 6, 20206 yr Author @steves53 Hi, is this a PilotEdge related question? Otherwise if it is a GTN question, please make sure to read the Garmin GTN Pilot's Guide for everything related to COM frequency tuning.
June 7, 20206 yr Thanks, thought I read the pilot guide and didn't see it. Maybe there is more to read, I'll take another look. Nothing to do with PilotEdge, sorry if this was the wrong forum for the question.
Archived
This topic is now archived and is closed to further replies.