Morning all

 

Firstly, I think these are very good.  

 

The only issue I have is not going there on first selection.  Here's a test.

 

1. On the UI  select a On-board View.  View changes to that view

2. Select an Outside view.  View changes to that view

3. Select Static view.  View changes to behind aircraft not the static view

4. Select the same static view again. View now moves to that view

 

 

Thanks

 

 

Clive

 

 

 

Are you selecting a static preset for steps 3 and 4?

 

Selecting the static view on its own, without choosing a preset, will default to placing the camera behind the aircraft. Likewise pressing reset camera at any point whilst using the static mode will place the camera behind the aircraft.

 

I don't quite understand the issue here, as it is difficult to tell what you are clicking on and whether or not you're using presets.

 

Hope this helps,

 

Max

thanks Max

 

 

Yep, looks like user issue this end :wink:

 

 

Case closed

We identified an issue where selecting a preset from the Static list would reset the camera behind the aircraft instead of placing it to the preset's location. We will fix that in the next update.

Thanks Kev

 

glad it was not just me  :wink:

We identified an issue where selecting a preset from the Static list would reset the camera behind the aircraft instead of placing it to the preset's location. We will fix that in the next update.

 

Also when changing to the default spot view the camera is always placed behind the aircraft. It would be nice if the last position of the spot view would be remembered