Hi,

Yesterday I used Chaseplane with FSLabs A320x and I found out that after changing the Turbulence settings in Camera section, whenever I press my hotkey to any view, it resets back to default. I thought it was A320x issue only but I tried again with PMDG MD-11 and same thing happen. I can set it, it works, but if I press any hotkey it goes back to default settings.

It was fine the last time I used it, probably several days ago.

I am using Experimental Version.

Thank you,
Hoang Le

Disable Experimental Version and it works normally, so it has to do with the new one I believed.
Hoang Le

No idea what makes this happen, but hat off and respect for flying MD-11! 

Damn, I just checked my sig. It probably makes difficult to understand why I said this... :D

1 hour ago, eNVee said:

No idea what makes this happen, but hat off and respect for flying MD-11! 

Damn, I just checked my sig. It probably makes difficult to understand why I said this... :D

Hi, I am reinstalling the Experimental Version to see if it works normally.
And..yes, PMDG MD-11 is one of the main reason that I have not made the switch to P3D. Such a wonderful piece of work that have got abandoned.
Cheers!
Hoang Le

Hi,
I still have this problem with FSLabs A320X with Experimental On.

Hello, any support of this issue?

My settings are from FSLABs A320x CFM engine. Today I fly the IAE engine, transfer the view from CFM engine and I can save the turbulence settings without the reset issue.

So it is still happening with CFM engine only.