FMC not going to Ident page

[uhntissbaby111 58]

Finally got p3dv4 up and running. Was doing some flights with the 744 and noticed on both occasions that when pressing the FMC lsk on the initial FMC page, it takes me to the perf init page instead of the ident page. Is anyone seeing this?

[Captain Kevin 586]

Had you already used the FMC at some point? I could be wrong, and I don't have time to test this right now, but I would think if you had already used it and had a route punched in and what not, it would take you there. Only other thing I could think of is a panel state issue. I know updating the 747 caused issues with my panel states, and I had to start over with the PMDG default panel states.

[uhntissbaby111 58]

No, it is on the first use of the FMC, nothing programmed in. And it is using the PMDG panel stares, not custom ones 

[Budbud 227]

Hi,

On my side, CDU goes to ident page when I press on the LSK "FMC" from the menu page at least the first time (I'm away from my sim computer so I cannot check what happens if I do the same after displaying some other pages.)