Hello,

i have recently installed P3Dv4 and am having a problem with my yoke (GF-Pro yoke system 737).

whenever i turn the yoke to the left, it also causes the view to pan left.

any idea why this is happening and how i can eliminate?

thanks in advance

Sounds like the axis used by the yoke when it is turned left is assigned a pan view.  

blaustern

i have checked the controls options but do not see any assignment of panning to the yoke.

no idea what is going on but i cant use the sim until i figure it out

Strangely enough, my GoFlight pro did exeactly as described (darn near crashed my PC-12 on landing at W16)

I have no idea what caused this, and it began suddenly. However I was using P3D V3 at the time (I have V4 installed)

av8r13, have you made any progress? Please let me know if there is anything I can help with. I am currently at a loss...

so, i somehow fixed this a couple of years ago. then for some reason my controls reset to default and now i have lost all my controls config.

the yoke aileron roll is now causing my view to pan again...and i can not remember how i fixed this...

very frustrating.

any idea how to fix this?? any idea what would cause my custom controls to dissappear??

Are you assigning the yoke via the default P3D control? If so, you could always install a free version of FSUIPC and then assign the controller through there, after unticking 'enable controllers' in P3D. It is a far better way of configuring your controller, as it allows you to have far more control over your yoke, as well as many other things too!