August 21, 20178 yr 2 hours ago, Lorby_SI said: Hi, I had the same issue with a different aircraft. Looking out of the VC, some of the lights (nav, strobe) were only visible while taxiing on the ground, but disappeared when taking off - while at the same time being visible when I switched to an outside view. Turned out it was a clipping issue. Setting the ClipMode=minimum in cameras.cfg for the VC camera solved it for me. But I am using EZDOK, not Chaseplane, so I don't know which camera definition is used by CP. Best regards the op has stated that he still has the issues with or with out using cp, Iam using cp and clipmode is set to minimum which most likely is default state when using cp. Might be good for the op to check though I7-8700k,Corsair h1101 cooler ,Asus Strix Gaming Intel Z370 S11 motherboard, Corsair 32gb ramDD4,, gtx 1080ti Card, RM850 power supply Peter kelberg
August 23, 20178 yr Author On 21/08/2017 at 11:13 AM, Lorby_SI said: Hi, I had the same issue with a different aircraft. Looking out of the VC, some of the lights (nav, strobe) were only visible while taxiing on the ground, but disappeared when taking off - while at the same time being visible when I switched to an outside view. Turned out it was a clipping issue. Setting the ClipMode=minimum in cameras.cfg for the VC camera solved it for me. But I am using EZDOK, not Chaseplane, so I don't know which camera definition is used by CP. Best regards Thanks, I'll look into it and post back if the fix worked at the weekend. Thanks Wayne Runner
Archived
This topic is now archived and is closed to further replies.