Trying to program my yoke with FSUIPC in the 777-200 in P3D 4.1 but it’s not working. No axis are being programmed. Yet in 4.0 all this would work fine any ideas what may be the problem?

Have you accidentally deactivated your controllers in the P3D controller settings? 

I turned them off in P3D controller settings so I can set them with FSUIPC but it’s not working

33 minutes ago, aushie said:

Trying to program my yoke with FSUIPC in the 777-200 in P3D 4.1 but it’s not working. No axis are being programmed. Yet in 4.0 all this would work fine any ideas what may be the problem?

This is an FSUIPC issue, and I'm willing to bet that it's a bad .ini from the earlier sim. When troubleshooting with FSUIPC, remove the ini first. Usually solves it.

Ok will try it

When you turn them off (untick controllers in general) in te p3d controller settings you can‘t use them via fsuipc either... delete the axes but activate the controllers.

3 minutes ago, Ephedrin said:

When you turn them off (untick controllers in general) in te p3d controller settings you can‘t use them via fsuipc either... delete the axes but activate the controllers.

They are ticked 

Ok then it smells like an ini thing ^^

20 minutes ago, Ephedrin said:

Ok then it smells like an ini thing ^^

Trying that issue now thanks

Can’t get it too work I tried a clean install the whole nine yards and no good. Must be an FSUIPC issue. The 737 works fine apart from trying to program the spoilers axis 

Can you explain what exactly you are doing in FSUIPC? Maybe it‘s just something little you miss? 

Do you use „send to FS“ or fsuipc calibration?

Send to FS 

Maybe my firewall is interfering or something

Bottom line is FSUIPC is not working right with my PMDG aircraft I’m going to go complain to Pete 

I figured it out it was send to FS calibration I wasn’t doing that