59 minutes ago, mdreyer said:

I use Matrox tripplehead2go. I found that using surround in nVidia I was limited to how much zoom I could use (It looked like I was sitting on dash board with my nose pressed up against the windshield!)

TH2GO isn't cheap, though I highly recommend it for 3 monitors.

Cheers.

Sounds like you did not have the wide view setting checked when trying Surround.

There is absolutely no advantage in using a Matrox here over a Surround setup. The same resolution with either setup will look exactly the same in the sim apart from the Matrox's clunky bevel correction, if you are using that.

gb.

1 hour ago, mdreyer said:

I found that using surround in nVidia I was limited to how much zoom I could use

TH2Go makes no difference to that. Regardless of whether you use TH2Go or nvidia Surround you are creating a single monitor as far as Windows (and FSX) is concerned. Either way you need to set WideViewAspect to give you enough zoom range.

 

[Dammit, too slow :) ]

2 minutes ago, MarkDH said:

Dammit, too slow :) ]

The quick and the dead. Lol.

gb.

2 hours ago, Boomer said:

Tried that and it blows.

Depends.

If you exceed 15 degrees on the outside monitors, yes.

If not, it works well; runways lines line up across all three pretty closely. I was surprised. I tried Surround and that blowed because max res was 1080; I run 2550 across all three. Fake 4k 

That said, Beau explains all this over at the LM forum in detail.

Cheers,

Mark