Gaaah. Thought I was past this...How can I get back the ability to open door 2,3,4 etc?I can only open door 1 with my current key assignments. (Shift+E)I

Well, this might help:http://library.avsim.net/search.php?Search....zip&CatID=rootRegards,

HI Johan,If you state "it used to work", you most problably have added an ill-behaving gauge to these panels.As "saudi" says: adding my gauge will solve it; the included README explains why.Cheers, Rob

OK, thanx guys. I think it

Rob,I think I've installed your gauge, but I'm struggling a little. If I install it in the VCockpit section will it only work when I'm in the VC rather than the 2D?Thanks,Mark

Hi Mark,I've tested it in both VC and 2D Cockpit.If you define the gauge in a 2D window section of the panel.cfg, it won't work until that window is visualised first.But after that, it will work in any view.But when defined in a Vcockpit section, the gauge will work in any View, no matter how you have loaded the aircraft.That is: it's intended to work like this.So, please check again.If you still have the problem that the gauge only works when your are in VC view, I would be very interrested to find out why.(because there's obviously a lack in my knowledge there, but I don't expect so :-) )In that case: please contact me via normal Email (see README)Cheers, Rob

Hi Rob,I think it may have been a case of RTFM. I hadn't put the gauge in an rcb-gauges folder, but had just dropped it in the main gauge folder. I feel suitably chastened for not reading the very clear instructions!

Hi Mark,Right :-) But I'm glad it DOES work OK ...Cheers, Rob