December 30, 20178 yr I'm feeling quite uncomfortable with the fact that changing aircraft or closing XP11, the simulation freezes for up to about 1(!) minute (... no, this is a fast machine ...)? Looks like the GTN750 performs some background procedures. Somebody encountered similar behaviour?
December 30, 20178 yr Author Version ... hm, I do have an idea, but I'm not sure. How can I retrieve the version number from a running installation?
December 30, 20178 yr Any 'rxp' log file shows the version first (see User's Manual for file/path). Speaking of which, when you switch from an RXP aircraft to a non-RXP aircraft, and after the 1min delay you are experiencing, don't touch anything and open the log files for additional information if any. This might indicate what is going on, it shouldn't take this long to close a device.
December 30, 20178 yr Author It is 2.4.10.0. Done as advised, no hints in rxpGTN.xpl.log and rxpGtnSim.dll.log.
December 30, 20178 yr 4 hours ago, RXP said: Hi Babbo, is this happening with the latest v2.4.12? 2 hours ago, Babbo said: It is 2.4.10.0. Well, it is easy: you are not using 2.4.12. Install 2.4.12 first and see if this solves the issue!
December 30, 20178 yr Author V.12 Installed, but no change. Clean logs after closing XP11. Waiting time between quitting XP11 and actual XP11-close about 110 seconds. Everything else is running fine and super-responsive.
December 31, 20178 yr This is most likely an XP11 issue, on my setup even a clean installation of XP hangs for 2 minutes when closing the app.
December 31, 20178 yr I have found that I have to switch the aircraft battery OFF before closing XP or it hangs on the active GTN when closing down for a few minutes.
December 31, 20178 yr Hi, this is peculiar and must be related to XP11 in some way, because when switching off the device, it actually stops the currently running trainer process and launches a new one, just waiting for power on. Although a trainer process in a power-off state is not using as much resources, it is still a process running. This, and the empty log file, tell at least the issue is not related to closing the trainer process. I'd guess the issue might just be XP11 as much to do and is stuck. Have you cross-check for example your XP11 GFX settings video card memory used, and if this is below the actual video card on-board memory size?
December 31, 20178 yr Author 30 minutes ago, RXP said: Have you cross-check for example your XP11 GFX settings video card memory used, ... How to do that?
December 31, 20178 yr Open the XP11 GFX settings, read the reported mem used under the 'texture size' slider!
December 31, 20178 yr Author @bluebell2: thanks - but failure in my case @RXP: If you mean the Texture Quality slider, here I have a note: "541 MB of textures currently loaded" (with default C172 and activated GTN750). Video card memory is 8 GB.
Archived
This topic is now archived and is closed to further replies.