Suggestions for improvement

[CKAJCA 1]

First I will apologise in advance if this is not the right place to put suggestions but I couldn't see anywhere else.

1) Is it possible OR would it be possible to have the option to have the radios detuned i.e no ATIS when connection is first made to the Sim? I believe that with the battery/avionics off there would be no audio from the radio but I would prefer to be able to tune into the ATIS when I want to.

2) This next issue makes ATC Chatter unusable for me. As an ex real world pilot I cannot get used to the fact that when I initiate contact with a controller ATC Chatter intervenes between my request and receiving a response from the controller. I dont know if there is a way to prevent this from happening in Pilot2ATC.

Regards Colin

[Dave-Pilot2ATC 870]

On #1, I have adjusted the program so that the auto setting of the radios upon connection will only happen if you have the "Copilot Changes Frequencies option checked.  This will be available in the next update.

On #2, if you set the Pause time between Chatter files high enough and wait until there is a break in the chatter before making a request, you should get the results you are looking for.  

Dave

Edited September 5, 2018 by Dave-Pilot2ATC

[CKAJCA 1]

4 minutes ago, Dave-Pilot2ATC said:

On #1, I have adjusted the program so that the auto setting of the radios upon connection will only happen if you have the "Copilot Changes Frequencies option checked.  This will be available in the next update.

On #2, if you set the Pause time between Chatter files high enough and wait until there is a break in the chatter before making a request, you should get the results you are looking for.  

Dave

Hi Dave

#1 That sounds great. Thanks

With respect to #2 my understanding was that the Pause time between Chatter files set the maximum time between Chatter files playing i.e it was a random time upto the maximum time in seconds input. If that is the case and I have started a dialog with a controller AND the random time selected by Pilot2ATC was a very short time then ATC Chatter would intervene between the receipt of an instruction by the controller and me responding?

[Dave-Pilot2ATC 870]

Yes, you are correct.  I will add a Minimum Pause Time variable that will allow setting both a minimum and maximum pause time.

Thanks,

Dave

[CKAJCA 1]

17 minutes ago, Dave-Pilot2ATC said:

Yes, you are correct.  I will add a Minimum Pause Time variable that will allow setting both a minimum and maximum pause time.

Thanks,

Dave

Perfect Dave. You are a STAR