September 22, 20187 yr Hi, I have recently tried to do a cold and dark start on the 777-300ER and when I got to setting up the route in the FMC I faced a problem. I set up the route (EHAM - EGLL) and added BAW452 as the flight number and ‘24’ as the runway. I added all the way points and then I clicked ‘save’. I saved with the name ‘EHAMEGLL’. Next I clicked ‘activate’ and everything was fine. Then when I clicked ‘execute’ it took me to the next step but removed the ICAO codes from where they were meant to be. The flight number and Co number were still there. It also removed the route from the nav display. It looked like the following: From To ———— ———— Flight number BAW452 Co number EHAMEGLL the from and to box had become empty. Also all the waypoints got erased. Please help as I searched everywhere!
September 22, 20187 yr Commercial Member 55 minutes ago, Jojo Ray said: the from and to box had become empty. Also all the waypoints got erased. Please help as I searched everywhere! Running the sim as an admin? Kyle Rodgers
September 22, 20187 yr Author 11 minutes ago, scandinavian13 said: Running the sim as an admin? Yes I always run it as admin
September 22, 20187 yr Try EXEC when your route is complete, then SAVE. I also always RTE COPY before I save to load it into RTE 2 but that is optional. Dan Downs KCRP
September 22, 20187 yr Author 2 hours ago, downscc said: Try EXEC when your route is complete, then SAVE. I also always RTE COPY before I save to load it into RTE 2 but that is optional. Ok I’ll try that, but what do you mean by when your route is complete? End of the flight or?
September 22, 20187 yr 24 minutes ago, Jojo Ray said: Ok I’ll try that, but what do you mean by when your route is complete? End of the flight or? When you have completed the entry of the route. When the route is in the FMS click EXEC. Now you have an active route to save or copy. The route is not active until you EXEC. Edited September 22, 20187 yr by downscc Dan Downs KCRP
September 22, 20187 yr Author 52 minutes ago, downscc said: When you have completed the entry of the route. When the route is in the FMS click EXEC. Now you have an active route to save or copy. The route is not active until you EXEC. I just did that and it worked! Can't thank you enough, now I can do those long haul flights!
Archived
This topic is now archived and is closed to further replies.